Body (Millipore, USA), cells were first fixed with 2 mM disuccinimidyl glutarate (DSG) (ProteoChem,Aprelikova et al. Clinical Epigenetics (2016) 8:Page 13 ofUSA) for 45 min at room temperature, followed by two washes with cold PBS and additional fixation with 1 formaldehyde for 15 min. ChIP assays were performed using a ChIP-IT High Sensitivity Kit from Active Motif (USA). Fixation was stopped by addition of 1/20 volume of stop buffer, and aliquots of 4 ?106 cells were lysed in 400 l of GGTI298 chemical information SDS-lysis buffer. DNA shearing was performed for a total of 16 min at high power setting in BIORUPTOR water bath sonicator (Diagenode, USA). Immunoprecipitation was performed with 1.4 g of anti-JMJD6 or 10 g of anti-H4R3me2a antibody or 40 l of V5-agarose (Sigma) at 4 overnight. DNA protein complexes were collected with protein G agarose beads and washed according to manufacturer’s instructions. After elution and reversal of crosslinking, samples were treated with RNase A and proteinase K and purified with QIAQuick PCR columns. PubMed ID:http://www.ncbi.nlm.nih.gov/pubmed/27488460 Five microliters of the eluted DNA was used for quantitative PCR analysis with SYBR Green qPCR master mix (Bio-Rad, USA). For mouse p19ARF, primers used [68] were forward primer 5-TTCCAGGCCTTGCCATCTTCCT AT-3 and reverse primer 5-TGGTCTGGCTGCAGT AAAGTAGCA-3. For human p14ARF, we used two pairs of primers: distal forward 5-CATTTCTGAGGA AGGGCTACTT-3 and distal reverse 5-GCCACCT TTCTGTCTAGTATGG-3, proximal forward 5-TCG CCAAGACAACCATTCTAC-3 and proximal reverse 5-CGCTTCTTCCTCTTTCCTCTTC-3. For amplification of mouse p16 promoter, the primers were forward 5-CAGATTGCCCTCCGATGACTTC-3 and reverse 5-TGGACCCGCACAGCAAAGAAGT-3. Primers for -globin used as a positive control were provided by Millipore together with ChIP quality antiJMJD6 antibody.Cell cytotoxicity assaydividing the first luminescence by second after subtraction of the background signal for media only. Each experiment was performed in triplicates and repeated 2? times. The CytoTox-Glo assay measures the number of dead cells irrespective of how cells died. To confirm that majority of cell die from apoptosis after Myc induction, we repeated the experiments, performing FACS analysis after staining the cells with FITC-Annexin V and propidium iodide using the Apoptosis Detection Kit (BD Pharmingen, USA). The data are shown in Additional file 1: Figure S9.Migration and invasion assay2 ?104 cells expressing JMJD6 or LacZ control were placed into the top compartment of transwell Boyden chambers (8 m, Corning, USA) in serum-free media. The lower compartment contained complete media with 10 FBS. For the invasion assay, we used the same setting with MatrigelTM-covered chambers prepared according to the manufacturer’s instructions (Corning, USA). After 24 h, migrated cells were fixed and stained with the Diff-Quik Stain Set (Dade Behring Inc., USA). The cells that migrated through the pores of the membrane were photographed and quantified using ImageJ software.Western blot analysisCells were seeded at 10,000 cells per well in 96-well non-transparent plates. The next day, cells were treated with 150 nM 4-hydroxytamoxifen (4-OHT) to induce Myc or with equal volume of EtOH as a control. Twenty-four hour later, cells were washed twice with PBS and the media was changed for “stress media” that included either serum-free media, glucose-free media, glutamine-free media, or 100 M etoposide. After 18?0 hours the percentage of dead cells relative to the total amount of cells was measured using.