Ed 97.four of properly classified samples. with only one typical band being discovered (1746 cm-1 ). The FCM analysis effectively Only one A. mellea sample overlapped around the B. edulis group. When kNN was Hexazinone Formula applied in classified the investigated mushroom samples in line with their species, which means that, in the exact same manner as LDA, the all round % of appropriately classified samples from the just about every partition, the predominant species had the largest DOMs, though samples belonging training step was 86.21 , even though for the holdout set, the % rose to 94.74 . The decrease to other species had reduced DOMs. values obtained for the coaching set had been as a result of 1 C. cibarius sample, two B. edulis, and This method, obtained through the synergy between the FT-IR analytical technique 5 A. mellea, which were placed to other species. In any case, for the holdout sample and different chemometric strategies, represents a suitable tool for species authentication of set, only 1 sample from B. edulis was misclassified. These two statistical strategies dried mushrooms, which could serve as fair trade. proved to become complementary, with only one popular band becoming discovered (1746 cm-1). The FCM analysis effectively classified the investigated mushroom and writing, I.F. and to Author Contributions: Conceptualization, methodology, samples according D.A.M.; sample their species, collection and analytic measurements, the predominant species hadsoftware processing I.F. and meaning that, in each partition, F.-D.C., R.P., C.V.F.-A. and O.M.; the largest DOMs, whileC.S.; writing, I.F., C.V.F.-A., F.-D.C. and O.M.;decrease DOMs. and C.S. All authors have read and samples belonging to other species had revision, D.A.M. This method,to the published version of synergy between the FT-IR analytical techagreed obtained by means of the the manuscript. nique and distinctive chemometric solutions, represents a suitable tool for species authenFunding: This work was supported by the Ministry of Study, Innovation, and Digitalization, tication of dried mushrooms, 90/2020, within PNCDI fair trade. grant number PD which could serve as III.Institutional Overview Board methodology, and writing, Author Contributions: Conceptualization, Statement: Not applicable. I.F. and D.A.M.; sample collection and analytic measurements, F.-D.C., R.P., C.V.F.-A., and O.M.; software program processing I.F. and Informed Consent Statement: Not applicable. C.S.; writing, I.F., C.V.F.-A., F.-D.C. and O.M.; revision, D.A.M. and C.S. All authors have read and Conflicts of Interest: The authors declare no conflict of interest. agreed towards the published version with the manuscript.Funding: This perform was supported by the Ministry of Research, Innovation, and Digitalization, grant quantity PD 90/2020, inside PNCDI III.Appl. Sci. 2021, 11,9 of
applied sciencesArticleOptimization Design and style of Extrusion Roller of RP1814 Roller Press Primarily based on ANSYS WorkbenchWeihua Wei 1, , Fangxu Peng 1 , Yingli Li 1 , Bingrui Chen 1 , Yiqi Xu 1 and Yu WeiCollege of Mechanical and Electronic Engineering, Nanjing Forestry University, Nanjing 210037, China; [email protected] (F.P.); [email protected] (Y.L.); [email protected] (B.C.); [email protected] (Y.X.) Jiangsu Hengyuan Hexythiazox manufacturer International Engineering Co., Ltd., Yangzhou 225266, China; [email protected] Correspondence: [email protected]; Tel.: +86-Abstract: Firstly, the force of an extrusion roller beneath actual working situation was analyzed while the speak to strain among the roller shaft and also the roller sleeve and th.