Ed 97.four of appropriately classified samples. with only one particular common band becoming identified (1746 cm-1 ). The FCM evaluation effectively Only one A. mellea sample overlapped around the B. edulis group. When kNN was employed in classified the investigated mushroom Enclomiphene Antagonist samples as outlined by their species, meaning that, within the very same manner as LDA, the overall percent of correctly classified samples in the each and every partition, the predominant Propargite supplier species had the largest DOMs, even though samples belonging instruction step was 86.21 , although for the holdout set, the % rose to 94.74 . The reduced to other species had decrease DOMs. values obtained for the coaching set had been resulting from a single C. cibarius sample, two B. edulis, and This method, obtained via the synergy involving the FT-IR analytical approach five A. mellea, which were placed to other species. In any case, for the holdout sample and unique chemometric strategies, represents a appropriate tool for species authentication of set, only a single sample from B. edulis was misclassified. These two statistical tactics dried mushrooms, which could serve as fair trade. proved to become complementary, with only one particular widespread band becoming discovered (1746 cm-1). The FCM analysis effectively classified the investigated mushroom and writing, I.F. and to Author Contributions: Conceptualization, methodology, samples according D.A.M.; sample their species, collection and analytic measurements, the predominant species hadsoftware processing I.F. and meaning that, in each partition, F.-D.C., R.P., C.V.F.-A. and O.M.; the most significant DOMs, whileC.S.; writing, I.F., C.V.F.-A., F.-D.C. and O.M.;reduce DOMs. and C.S. All authors have study and samples belonging to other species had revision, D.A.M. This approach,for the published version of synergy involving the FT-IR analytical techagreed obtained by means of the the manuscript. nique and diverse chemometric approaches, represents a appropriate tool for species authenFunding: This operate was supported by the Ministry of Research, Innovation, and Digitalization, tication of dried mushrooms, 90/2020, inside PNCDI fair trade. grant number PD which could serve as III.Institutional Evaluation Board methodology, and writing, Author Contributions: Conceptualization, Statement: Not applicable. I.F. and D.A.M.; sample collection and analytic measurements, F.-D.C., R.P., C.V.F.-A., and O.M.; software processing I.F. and Informed Consent Statement: Not applicable. C.S.; writing, I.F., C.V.F.-A., F.-D.C. and O.M.; revision, D.A.M. and C.S. All authors have read and Conflicts of Interest: The authors declare no conflict of interest. agreed for the published version with the manuscript.Funding: This work was supported by the Ministry of Research, Innovation, and Digitalization, grant number PD 90/2020, inside PNCDI III.Appl. Sci. 2021, 11,9 of
applied sciencesArticleOptimization Style of Extrusion Roller of RP1814 Roller Press Based on ANSYS WorkbenchWeihua Wei 1, , Fangxu Peng 1 , Yingli Li 1 , Bingrui Chen 1 , Yiqi Xu 1 and Yu WeiCollege of Mechanical and Electronic Engineering, Nanjing Forestry University, Nanjing 210037, China; [email protected] (F.P.); [email protected] (Y.L.); [email protected] (B.C.); [email protected] (Y.X.) Jiangsu Hengyuan International Engineering Co., Ltd., Yangzhou 225266, China; [email protected] Correspondence: [email protected]; Tel.: +86-Abstract: Firstly, the force of an extrusion roller under actual functioning condition was analyzed although the make contact with tension involving the roller shaft plus the roller sleeve and th.